PNEUMATIC TRANSPORT

DENSE PHASE

This type of transport uses a pressure tank that works by cycles; that is to say, the product is loaded up to a certain level and then sent to its point of destiny.

It is useful in rubber, foodstuffs, chemical, plastics, ceramics, and environmental and waste transport sectors.

EUROTEK has two types of transmitters to cover the full range of dense phase pneumatic transport applications.  II-PRO EMITTER and VENTURI-EMITTER

II-PRO EMITTER

Application: Careful transport of fragile and / or abrasive products. When transporting fragile products we have to take care to avoid breakages of the product; when transporting abrasive products we have to reduce wear of the rubbing, especially the elbows due to low transport speed.

II-PRO MINI EMITTER

Application: For reduced spaces and small quantities of material being transported.

transporte neumático fase densa

FEATURES:

  • Reduced energy cost
  • Low pulling speed (between 1 and 5 m/s)
  • Slow and careful transport from about 1 m/s.
  • Reduced wear with abrasive products
  • Optimal system for shipping prepared mixture Disaggregation of the mixture is avoided by sending the product “in grouped portions”.
  • Construction in Stainless steel (AISI 304 and 316L), Carbon steel.
  • Construction standards:  (ISO, ASME, AD-MERKBLATTER)
  • Industrial approval
  • Classified area:  Construction for ATEX explosive atmospheres

ACCESSORIES:

  • Installation of load detectors to control the use of the transported material
  • Support stations according to the distance and fragility of the product
  • Own designed intelligent stations for highly fragile products (like toasted coffee grains, or lampblack pellets).
  • Vibration at outlet elbow, for the transport of cohesive powders
  • Detailed selection of the type of material used in the elbows and changes of direction for the transported material, according to the abrasiveness of the product.
  • Electrical control panel with PLC for control of pneumatic transport.
  • Statistic control of pressure for maintenance tasks. All abnormalities that may occur throughout the useful life of the transmitter (leaks, wear of elements, incrustations of product...), are foreseen with this system.

 

VENTURI EMITTER

Application: Lines that need large capacities of transport of materials with a medium-low index of abrasion: suspended ash, carbonate, cement, plaster, perlite, and/or industrial fertiliser.

transporte neumático fase densa

FEATURES:

  • High transport capacity (up to 120 Ton/h)
  • Long distances for transport (up to 500 m)
  • Construction in Stainless steel (AISI 304 and 316L), Carbon steel
  • Construction standards:  (ISO, ASME, AD-MERKBLATTER)
  • Industrial approval
  • Classified area:  Construction for ATEX explosive atmospheres

ACCESSORIES:

  • Installation of load detectors to control the use of the transported material
  • Own designed EMIFLUX chamber injector to fluidise materials and reduce friction.  
  • Highly porous lower membrane for situations that require increasing the transport capacity.
  • Electrical control panel with PLC for control of pneumatic transport.
  • Statistic control of pressure for maintenance tasks. All abnormalities that may occur throughout the useful life of the transmitter (leaks, wear of elements, incrustations of product...), are foreseen with this system.